Search results

Not Shure if this would help or not but I also had some crazy bugs with the firmware till i did a factory reset then upgraded firmware and reprogramed all the cameras and settings back in, real pain in the but for Shure but fixed all my issues.

No it does NOT support 30fps, after the recovery. But if you have a bricked LNB9232s or a LNB9272 it will recover them to a working condition!!! also note that if you recover a 9272 you will NOT have zoom and auto focus also limited to 15 fps. If any one out there could supply us with factory...

Well i can confirm it works on the lnb 9232 and the lnb 9272 thanks again,

OMG thankyou so much!!!!

Well guys cant say that i did not try LOL. I now have a brick to hold down my papers on the desk!!! best part about it is Lorex cannot even supply the original firmware.

Thankyou so for trying!!! at least you found a firmware with cayenne in it, I must have downloaded at least 50 firmware's looking .it gives me a little hope! also just for shits and giggles i tried to load it :) but no success. I cant believe that Lorex does not have a newer firmware for it. My...

Its almost identical to the IPC-HFW2831T-ZAS minus the card slot, in the above photos you can see a header that most likely connects to a card slot.

Ok I tried tftp but was not successful i do feel that I'm close, just missing something simple any ideas? Below is the Lorex camera ID. IPC-HFW2831TN-ZA-3711-CAYENNE:01:02:02:64:2C:00:01:0F:01:01:00:320:00:00:00:00:00:01:00:00:200 this is the check image file on the new firmware the hardware...

Hello all, i am hoping there is someone that could help me load Dahua firmware on Lorex lnb9272s cameras? I Have been reading the forums like crazy but i am still unsure if it is even possible. so i get the sys info from the camera as seen below...

Hope this may help someone, I have taken the Lorex lnb9232 apart because I somehow messed up the password and needed to reset it back to default, it was very easy to do once you remove the front face of the camera there is a small button just under the infra red led connector, no need to...