Hi,
I have a little ANR problem and wondering if someone can help me.
I have model DS-7608NI-I2 / 8P nvr and model DS-2CD2121G1-IDW1 camera. Camera is located on a moving forklift. My problem was that camera needs to change wifi access point frequently and there are 1-2 minute blackouts in recordings.
I have enabled ANR in the nvr and tried different pre- and post-recording durations. I watch recordings in iVMS-4200 client and have noticed couple of problems / questions.
1. There are still little skips (~15 seconds) in the recordins even if I set pre-record to not limited and post-record to 10 minutes or set both values to any other smaller. So it doesn't overwrite to the nvr backwards enough or something. Like I said blackouts are max. 2 minutes long when changing wifi access point.
2. In iVMS-4200 playback shows now green blocks in the timeline when there are connection problems and that's like it should be. However when I playback footage and it reaches end of green block it jumps back to the some previous point in the green area and plays again same footage. Then continues normally.
3. Do I have to adjust pre- and post-record settings in the camera also?
Nvr and camera time settings are synchronized. Tried both encodings H.264 and H.265, H.264+/H.265+ OFF. Tried different transfer protocols and are now set to AUTO.
Appreciate any help, thanks.
I have a little ANR problem and wondering if someone can help me.
I have model DS-7608NI-I2 / 8P nvr and model DS-2CD2121G1-IDW1 camera. Camera is located on a moving forklift. My problem was that camera needs to change wifi access point frequently and there are 1-2 minute blackouts in recordings.
I have enabled ANR in the nvr and tried different pre- and post-recording durations. I watch recordings in iVMS-4200 client and have noticed couple of problems / questions.
1. There are still little skips (~15 seconds) in the recordins even if I set pre-record to not limited and post-record to 10 minutes or set both values to any other smaller. So it doesn't overwrite to the nvr backwards enough or something. Like I said blackouts are max. 2 minutes long when changing wifi access point.
2. In iVMS-4200 playback shows now green blocks in the timeline when there are connection problems and that's like it should be. However when I playback footage and it reaches end of green block it jumps back to the some previous point in the green area and plays again same footage. Then continues normally.
3. Do I have to adjust pre- and post-record settings in the camera also?
Nvr and camera time settings are synchronized. Tried both encodings H.264 and H.265, H.264+/H.265+ OFF. Tried different transfer protocols and are now set to AUTO.
Appreciate any help, thanks.