Blueiris & SeaLevel - DAC output enabled while camera is triggered

[DCorwin822]

I have unique requirement where in a interview room the cameras need to be toggled w/ a toggle switch. I have that working currently with my SeaLevel SeaDAC lite.

What I want is a indicator to be turned on while recording. I was hoping to use the SeaDAC's open relays to close a circuit for a LED indicator. I can't see where or figure out what needs to set the output of the DAC while the camera is triggered. Any assistance would be appreciated.


Thanks!

 

[DCorwin822]

Never mind, I figured it out.
In each camera, under trigger tab:
Set DIO input bits 1,2,4,8,16,32,64,128.
Set break time: end trigger to 10s, max trigger to 0.
Under immediate actions add a "do command" and set the command to "set output 1" or what ever the output # is.

then under the Alerts tab, open the "on reset" window. there set another "do command" and put the command to "reset output 1" or whatver the output # is.

I attached a couple of pictures of my settings. Hope this helps someone in the future.