Migrated from Sighthound to BI to trial it. A few hours to setup the basics and after a few days of operation I notice the cameras randomly disconnect. Have to restart at least one a day at random times using switch power cycle. Didn't have this issue with Sighthound in the same box. Cameras are Aote W511G-T-POE hardwired. Status reports signal loss with main stream still streaming about double the normal packets with <1 fps and substream completely dead framerate and data on the last instance. Using network configuration as populated by find/inspect. Is a BI restart needed after every config modification to be stable? Any suggestions are appreciated.
Cam: No signal occurs occasionally
- Thread starter markn62
- Start date
So you are saying that it reports signal loss yet the video is still streaming?
If so, this is one of the OCD type events that can drive you nuts that you have to learn to ignore. There are certain things that BI will throw "errors" that are really more like a caution "hey look at this" type indicator. iframes more than double FPS, FPS dropping low, etc. and with some cameras you do not have the ability to adjust anything to stop those "errors".
If you are losing signal, then it is because BI tends to be more sensitive to fluctuations as it would rather error on the side of caution and alerting you of an issue.
If so, this is one of the OCD type events that can drive you nuts that you have to learn to ignore. There are certain things that BI will throw "errors" that are really more like a caution "hey look at this" type indicator. iframes more than double FPS, FPS dropping low, etc. and with some cameras you do not have the ability to adjust anything to stop those "errors".
If you are losing signal, then it is because BI tends to be more sensitive to fluctuations as it would rather error on the side of caution and alerting you of an issue.
More than an OCD moment. No, the video is gone. Just stating what the "status" is reporting, that data is still flowing between the camera main and BI. Caught in a data bounce, got no idea why data was still flowing. Thought I'd mention that it might be a clue as to why. As I write this just had three cams go down all with the same status, Signal loss, main & sub stream 0fps, Main stream 1200kB/s - 1900kB/s, sub 0kB/s.
Just two layer-2 switches between cams & PC. Cam and PC on same subnet, single NIC. so router not involved.