Dahua IPC-HFW2325S-W can't find any WiFi

tasicss

tasicss

n3wb
Jun 4, 2023
9
5
Serbia
Hi folks,
I have problem with Dahua IPC-HFW2325S-W, camera works great on LAN cable but i can't find wifi around, 2.4 or 5.0GHz no change. Also i try manually set wifi and at all set default settings - no change, try to find firmware for this model on official site but again no sucess. Any one have correct firmware for this model or any idea is welcome!
 

Attachments

  • Untitled.jpg
    Untitled.jpg
    73.4 KB · Views: 13
tasicss said:
Hi folks,
I have problem with Dahua IPC-HFW2325S-W, camera works great on LAN cable but i can't find wifi around, 2.4 or 5.0GHz no change. Also i try manually set wifi and at all set default settings - no change, try to find firmware for this model on official site but again no sucess. Any one have correct firmware for this model or any idea is welcome!
Click to expand...
Did you make an earlier post about a Dahua IPC- HFW1320S-W with the same issue?
You did click on "Search SSID" button, right?
 
  • Like
Reactions: JDreaming
Last edited:
Yes i have dual 2,4 + GHz, but can find any wifi, from neighborhood also. Try to flash firmware but there no any changes. I think wifi module is dead, no more try im allready buy new camera.
 
Try to run api command:

curl -g --digest -u "<user>:<pass>" "http://<ipaddr>/cgi-bin/wlan.cgi?action=scanWlanDevices"

or go to link http://<ipaddr>/cgi-bin/wlan.cgi?action=scanWlanDevices and see if it returns anything.
 
  • Like
Reactions: tasicss and TonyR
tasicss said:
Where i can type this command, how?
Click to expand...
Open a browser and type in the URL as below, put in your camera's IP address where it has <ipaddr> and hit <enter>. Works great with both of my wired/wireless Amcrest (Dahua OEM) IP2M-841's, I am using Brave, a Chromium-based browser like Edge or Chrome. You'll be asked for the camera's username and password.:

Code: 
http://<ipaddr>/cgi-bin/wlan.cgi?action=scanWlanDevices

You can also include the username/password in the URL, such as :

Code: 
http://username:password@<ipaddr>/cgi-bin/wlan.cgi?action=scanWlanDevices
 
  • Like
Reactions: tasicss and helooham
tasicss said:
I try comannd buy says: found=0
Looks like wifi module is dead.
Click to expand...
I assume there is an antenna attached and if so, since it shows "enabled" in your first post and "found=0" is the response you get I'd agree that the wireless module is dead. :confused:

EDITED @ 1502 CDT 11/20/25: As a last ditch effort and if you're up to it, open the camera and make sure that the antenna is connected at its base inside and the other end to a PCB/wireless module. It may have come loose if the threaded part got spun around due to a loose nut OR the delicate snap-on connector became detached at the wireless module.
 
Last edited:
After all no more try, i will buy new modern camera, i try all but for replacement wifi module i need some special tool like microscope and m much cheaper to replace whole camera.
Thank you all for helping me resolving problem!
 
  • Haha
Reactions: TonyR
You must log in or register to reply here.
Top Bottom