Dahua NVR 4416-16p wont boot up

[Philski Phil]

I have the problem with my Dahua NVR 4416-16p.

There are two red led lights on the motherboard showing.

NVR wont boot up only turn on from the back power button.

None of the buttons on the front work when pressed..

Is it a hard disk problem?

Is the motherboard gone?

Any ideas?

regards

Phil

 

[cmos]

The NVR will run fine without a hard disk attached so remove the disk and try again. If still no boot either mother board or power supply.

 

[Philski Phil]

Hi Cmos,
Thanks for that information, I also disconnected the hard disks and switch it back on.
Still no luck, same problem NVR powers up but no boot up just the red led lights on the motherboard. None of the buttons on the front panel function when pressed.
Do you still think its a power supply problem or motherboard problem?

 

[cmos]

Most likely the mother board then.

 

[Philski Phil]

Thanks Cmos

So you think its time for a new NVR then? Non repairable?