Anybody have a clue for what's causing this? About once a week, very approximately, the 5216-4ks2 NVR changes the record schedule for the 2 thermal camera channels from the first picture to the second picture. Happens only with the thermal camera.
Dahua NVR resetting schedule settings for thermal camera
- Thread starter tigerwillow1
- Start date
bigredfish
Known around here
One is channel 4 and one is channel 5?
I dont have mine hooked up currently but I recall on my model the thermal channel didnt have IVS
I dont have mine hooked up currently but I recall on my model the thermal channel didnt have IVS
The thermal channels are 5 and 6, and they get changed together. I was just using 4 as an illustration and after I took the snapshots copied 4 into 5 and 6. It will likely hold for at least a few days. The camera is one that Andy still sells and has IVS on both channels. Can the camera change the schedule in the NVR? Maybe somebody knows....
bigredfish
Known around here
Like on any camera, If I make setting changes on the camera GUI, it will push much/most of that setting information back to the NVR
The problem people get into is that its not reliable going the other direction - Changes on NVR>>>Camera doesnt work well sometimes.
The problem people get into is that its not reliable going the other direction - Changes on NVR>>>Camera doesnt work well sometimes.
Is this camera connected to BI?
If so, we have seen some instances of BI changes settings in the camera (I have only seen it in the PTZ turning on MD/SMD), but maybe BI is changing a setting in the camera and then the camera is changing it in the NVR?
So if it is connected to BI, remove it from BI for a week and see if it goes away.
If so, we have seen some instances of BI changes settings in the camera (I have only seen it in the PTZ turning on MD/SMD), but maybe BI is changing a setting in the camera and then the camera is changing it in the NVR?
So if it is connected to BI, remove it from BI for a week and see if it goes away.