Printenv Command Not working
System startup
U-Boot 2010.06-svn4554 (May 13 2024 - 21:26:04)
Check Flash Memory Controller v100 ... Found
SPI Nand total size: 128MB
Erasing Nand...
Erasing at 0x400000 -- 100% complete.
Erasing at 0x500000 -- 100% complete.
pure data length is 131072, len_incl_bad is 131072
Erasing at 0x580000 -- 100% complete.
pure data length is 131072, len_incl_bad is 131072
done
===============================================
DPLL:466Mhz DDR:1864Mhz
APLL:1400Mhz VPLL0:297Mhz
===============================================
nice find PHY TRL8211 on higmac
ETH0: PHY(phyaddr=0, rgmii) not link!
higmac init fail!
mcu i2c fail
mem= 482
Config/hwidconfig not found!
Hit any key to stop autoboot: 0
hisilicon # printenv
Unknown command 'printenv' - try 'help'
hisilicon #
System startup
U-Boot 2010.06-svn4554 (May 13 2024 - 21:26:04)
Check Flash Memory Controller v100 ... Found
SPI Nand total size: 128MB
Erasing Nand...
Erasing at 0x400000 -- 100% complete.
Erasing at 0x500000 -- 100% complete.
pure data length is 131072, len_incl_bad is 131072
Erasing at 0x580000 -- 100% complete.
pure data length is 131072, len_incl_bad is 131072
done
===============================================
DPLL:466Mhz DDR:1864Mhz
APLL:1400Mhz VPLL0:297Mhz
===============================================
nice find PHY TRL8211 on higmac
ETH0: PHY(phyaddr=0, rgmii) not link!
higmac init fail!
mcu i2c fail
mem= 482
Config/hwidconfig not found!
Hit any key to stop autoboot: 0
hisilicon # printenv
Unknown command 'printenv' - try 'help'
hisilicon #