Enable remote notifications with alarm I/O

E

enabl3D

n3wb
Jul 31, 2017
5
0
I'm currently able to remote view and receive intrusion detection alerts via HIK-CONNECT.
NVR is DS-7608-E2+8P and one of my cameras has an I/O interface. All my cameras are setup with motion disabled and intrusion detection enabled.
Is it possible to setup the NVR/cameras to only notify the surveillance station when the alarm input on this specific camera is triggered? The purpose is to receive HIK-CONNECT notifications only when my alarm system is armed (which I will wire to the camera input).

Thanks
 
It should be possible.

I still have not used HIK-CONNECT/P2P for push alerts, but that would be no problem when connecting to the camera with fixed IP/DDNS/HiDDNS.
 
Any specific directions I should play with? Right now I have continuous recording on. Under Basic Events I have the following option:

upload_2017-9-9_15-29-54.png
Each of my cameras is setup up as this:
upload_2017-9-9_15-31-6.png
 
You must log in or register to reply here.
Top Bottom