Hope someone can help me with this. I just installed a new camera with my Dahua NVR. No problems with that, but when I try to access the camera (on channel 2) to make settings via the web interface on my computer, I get the message: “Please use HTTPS to access” I have never had that happen before. If I click on any of the other cameras via the interface, they come up just fine.
Since access wasn’t working on the browser (Chrome) on the Mac, I tried using the Dahua Config tool, and had the same difficulty. I then switched over to a PC to try to access channel 2 to set up the camera with IE, but the same thing. Any ideas on what I could do to regain access? I tried searching the forums but came up empty with results.
Here is a pic.
Since access wasn’t working on the browser (Chrome) on the Mac, I tried using the Dahua Config tool, and had the same difficulty. I then switched over to a PC to try to access channel 2 to set up the camera with IE, but the same thing. Any ideas on what I could do to regain access? I tried searching the forums but came up empty with results.
Here is a pic.
