ip cam and dvr dahua

[Davidealex]

hi, I have a dahua XVR5116HS-X with two cameras connected IPC-HFW2230S-S-S2. All products are dahua except ahd cameras. There is a jerky video problem with ip cameras when I watch the video on the monitor connected to the dvr. This problem is only with ip cameras, not ahd. There is a solution?

 

[bigredfish]

Does the recorded video do this or only live view
Post a recorded clip

 

[Davidealex]

only in live mode from dvr. The recordings no problems. Live/recording in Smartpss is ok.

 

[bigredfish]

Hmmmm that’s odd, that xvr should easily handle live view of a 2MP camera. I have 2 XVR s that run fine with multiple 4MP cams.

it shouldn’t matter but make sure the cams are set to match the XVR either ntsc or pal

 

[Davidealex]

yes, cam side and xvr side panel, there is set pal.

 

[Davidealex]

every 10 seconds there is a little jerky , it's not a big deal but it's annoying.

 

[bigredfish]

Unless its an issue with the monitor itself? Using thr HDMI or serial port? Maybe try the other?

 

[Davidealex]

before there was connected the vga, I also tried with hdmi but it does the same

 

[Davidealex]

in the cam settings i tried:
change of codecs
change of resolution
change of bitrate
type of encoding
also i did other tests on the xvr parameters.
I also reset everything, but the problem remains.

 

[bigredfish]

I'm stumped. Unless its the monitor. I use Smartpss and havent used the direct machine interface in some time.

 

[Davidealex]

Yes me too. i noticed this by chance, while looking at the dvr monitor