Model: N882A6 LorexNVR. Onvif Version 2.4.1. Firmware version 00011
The issue:
Go to setup -> recording -> and select "Main Stream" Type: and it's always reading Continuous even though I have set it to Motion Detect multiple times. (i hit "OK" to confirm changes)
Go to setup -> recording -> and select "Mode" and it always reads Timing even though I have set it to Trigger multiple times.
The other 3 cameras honor their settings.
If I go to a different tab, Camera 1 always reverts back to a Continuous stream, and Timing for snapshots.
I had it set to upload motion detected intrusions to a back-up FTP site, but as you can imagine, it's constantly sending video and snapshots at intervals.
I've set up the check boxes for Motion Detection on the Network -> FTP tab too. Doesn't seem to matter.
I've tried setting this on the device and also remotely. Same problematic result.
How do I make the setting stick for camera 1? The other three cameras work fine. Any way to SSH to a CLI on the Lorex NVR and manually edit the .conf files?
The issue:
Go to setup -> recording -> and select "Main Stream" Type: and it's always reading Continuous even though I have set it to Motion Detect multiple times. (i hit "OK" to confirm changes)
Go to setup -> recording -> and select "Mode" and it always reads Timing even though I have set it to Trigger multiple times.
The other 3 cameras honor their settings.
If I go to a different tab, Camera 1 always reverts back to a Continuous stream, and Timing for snapshots.
I had it set to upload motion detected intrusions to a back-up FTP site, but as you can imagine, it's constantly sending video and snapshots at intervals.
I've set up the check boxes for Motion Detection on the Network -> FTP tab too. Doesn't seem to matter.
I've tried setting this on the device and also remotely. Same problematic result.
How do I make the setting stick for camera 1? The other three cameras work fine. Any way to SSH to a CLI on the Lorex NVR and manually edit the .conf files?