Hi,
I have a few cameras that I have recently updated to 5.6.6 (to try and fix this issue). Basically I have always had dynamic motion analysis enabled and it’s worked fine, both showing current motion in live view and motion during playback. However I have noticed recently after moving home and having to setup motion detection again that this appears to no longer be working. During live view it highlights motion regardless of the sensitivity or percentage I have set, so even a sensitivity of 1 and percentage of 100 still shows motion even though it shouldn’t. If I change to basic from advanced the sensitivity does seem to have an effect on the green highlights with 0 sensitivity not highlighting anything as expected. Regardless of any of the above motion is no longer ever shown on recordings which is making tweaking exceptionally difficult. I am doing all of this via the WebUI as I do not have an NVR.
Any help greatly appreciated.
Thank you.
I have a few cameras that I have recently updated to 5.6.6 (to try and fix this issue). Basically I have always had dynamic motion analysis enabled and it’s worked fine, both showing current motion in live view and motion during playback. However I have noticed recently after moving home and having to setup motion detection again that this appears to no longer be working. During live view it highlights motion regardless of the sensitivity or percentage I have set, so even a sensitivity of 1 and percentage of 100 still shows motion even though it shouldn’t. If I change to basic from advanced the sensitivity does seem to have an effect on the green highlights with 0 sensitivity not highlighting anything as expected. Regardless of any of the above motion is no longer ever shown on recordings which is making tweaking exceptionally difficult. I am doing all of this via the WebUI as I do not have an NVR.
Any help greatly appreciated.
Thank you.
