I have a PTZ camera looking straight at the gate on my driveway. When a vehicle approaches they are driving straight toward the camera. I would like to set the camera up so if a vehicle comes through the gate, the camera will run a routine and change the presets. I know BI has added tracking but I do not want it to track everything. If a deer or other animal crosses in front of the camera I want it to alert but not change preset. So I cloned the PTZ camera and set up zones A>B so if a car travels from zone A to Zone B it will start the routine that's programmed in the cloned camera. I have zone G set up on non cloned camera which will alert on any motion but it does not change the preset. Problem is when I run the test from BI console, it works. But when I actually drive down the driveway and through the gate it does not. I have spent hours trying to figure this out. Does anyone have any ideas what I am missing? Thanks