For a few years I had a Dahua nvr hooked to four Dahua cameras. It was easy to set up and everything worked fine. I used the DMSS app. I had it set up to where notifications would pop up on my lock screen on my iphone when motion was detected. I just bought another nvr that has more channels. It’s a ENS diamond nvr302a. I have everything hooked up and it all works fine except I can’t set up phone notifications. If I unplug everything and plug it back into the old nvr it works fine and sends my iphone notifications when there is motion. So all my phone and app settings should be fine. Is there something in the nvr settings I have wrong? My old one was very easy to set up but maybe this nvr isn’t. I didn’t have to do anything in my old nvr’s settings to make the notifications work. I looked all through the manual but I can’t figure it out. I don’t know too much about this stuff.