NVR uart ports - where are they?

[ebebe]

Hello guys, seeking for your help... Was figuring for a few hours where are RS232/uart ports on this motherboard but I have no idea. Maybe someone knows?
I marked ports used by the HDD






Thanks for any tips...

 

[Revo2Maxx]

Well if it is the device I think it is, Then there is no RS485 or 232 offered on this model. However if you are looking for Config Port it might be the little connector next tot he printed NVR3009S1.. Outside of that looking for Communications port to connect a older style PTZ controller that NVR again if it is the device I think it is, Don't have one..

 

[ebebe]

I was wondering if this connector can be the UART port, although it looks like for the fan (that isn't even in the NVR box btw) Thanks for advice, I'll check this out

 

[Revo2Maxx]

Fan? If the NVR had a fan it would normally be a 2 pin 12v or 5v setup depending on device seeing I have a good many DVR/NVRs and even though they are from same company the Fans are not always the same voltage on different model of recorder.. This picture is from one of the lower prices AI NVRs I bought last year, It was time to give it a clean out seeing I like to do it at least once a year. Anyway I unplugged the Fan so you could see where it was plugged in at.. Only time I have seen a Fan connector like the one you think was on your PCB was on a PTZ camera.

 

[ebebe]

good advice man, after a few attemps I was able to putty inside
Just in case if somebody will be wondering on this motherboard too:


And voilaa

 

[Revo2Maxx]

Awesome glad you got it worked out.. Good Luck