Hi all,
I posted this in the installation forum but folks noted it might be better to post here, so I am reposting here!
We are looking to add 2 wide and 2 LPR cameras to help capture plates of cars entering and leaving the subdivision.
Here are the most important shots
1) Rear plate of cars exiting neighborhood (upper left yellow box). I would like to capture front plates of cars entering on the other side of the road too if possible. The yellow box covers both areas.
2) Rear plate of cars entering the gate (lower right yellow box). I would like to capture front plates of cars exiting on the other side of the road too if possible. The yellow box covers both areas.
80% of the traffic comes from and goes to the south side of the main road, indicated by the red arrows.
The NVR and network switch is located in the mailbox on the top right corner of the picture. We will be running conduit and ethernet and installing a new pole for these cameras.
I posted this in the installation forum but folks noted it might be better to post here, so I am reposting here!
We are looking to add 2 wide and 2 LPR cameras to help capture plates of cars entering and leaving the subdivision.
Here are the most important shots
1) Rear plate of cars exiting neighborhood (upper left yellow box). I would like to capture front plates of cars entering on the other side of the road too if possible. The yellow box covers both areas.
2) Rear plate of cars entering the gate (lower right yellow box). I would like to capture front plates of cars exiting on the other side of the road too if possible. The yellow box covers both areas.
80% of the traffic comes from and goes to the south side of the main road, indicated by the red arrows.
The NVR and network switch is located in the mailbox on the top right corner of the picture. We will be running conduit and ethernet and installing a new pole for these cameras.
- Would Option 1 or Option 2 have the best chance at capturing the plates in the locations listed above? I was thinking Option 2 might be better because at night, car headlights entering the neighborhood might shine into the camera if located in Option 1, but perhaps at 10ft it wouldn't matter? The downside to option 2 is that we would have to run cabling under the road, which will add significant cost to the project
- What is the best heigh to install the LPR cameras at for these angles? There will also be a wide camera mounted next to the LPR for each direction.
