The camera stopped working. Could not login to the web interface. Ping 192.168.1.108 is available. The camera reboots after 1 minute. The pin sensor does not click.
HWID=IPC-HDBW5631R-AS:01:02:05:hide
devalias=IPC-HDBW4631R-AS
What did I do?
Connect the UART, we see in the console
downloaded DH_IPC-HX5X3X-Rhea_Chn_PN_Stream3_V2.800.0000030.0.R.240614
I launched the TFTP server and only updated via UART:
Now when the camera loads, you can already hear that the sensor is triggered
Tell me how to revive the camera? Perhaps this is not a software glitch?
HWID=IPC-HDBW5631R-AS:01:02:05:hide
devalias=IPC-HDBW4631R-AS
What did I do?
Connect the UART, we see in the console
============================
U-Boot 2010.06-svn5733 (Aug 12 2018 - 00:33:23)
I2C: ready
DRAM: 118 MiB
gBootLogPtr:00b80008.
spinor flash ID is 0x1940ef
partition file version 2
rootfstype squashfs root /dev/mtdblock5
gParameter[0]:node=bootargs, parameter=console=ttyS0,115200 mem=130M root=/dev/mtdblock5 rootfstype=squashfs init=/linuxrc.
TEXT_BASE:01000000
Net: Detected MACID:hide
PHY:0x001cc816,addr:0x00
s3l phy RTL8201 init
partition file version 2
rootfstype squashfs root /dev/mtdblock5
MMC: sdmmc init
Using ambarella mac device
TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'upgrade_info_7db780a713a4.txt'.
Download to address: 0x5000000
Downloading: *
Retry count exceeded; starting again
Try again use backup_serverip
*** ERROR: `serverip' not set
Failed to get info.txt
Fail to get info file!
Init error!
Using ambarella mac device
TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'failed.txt'.
Download to address: 0x2000000
Downloading: *
Retry count exceeded; starting again
Support backupVer:255
state:ff,err_count:03
Adjust Memory Allocation, dram_size=0x8200000, dsp_ram.start=0x8400000, dsp_ram.size=0x17c00000
fail to load bootargsParameters.txt
fail to load bootargsParameters.txt file
hmagic=0xffffffff
Before write boot backup version page, it should be erased!!!
SPI probe: 32768 KiB W25Q256FV at 0:0 is now current device
## Booting kernel from Legacy Image at 02000000 ...
Image Name: Linux-3.10.73
Created: 2018-08-11 16:38:49 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1570072 Bytes = 1.5 MiB
Load Address: 00208000
Entry Point: 00208000
Verifying Checksum ... OK
Loading Kernel Image ...OK
OK
partition file version 2
rootfstype squashfs root /dev/mtdblock5
fail to load bootargsParameters.txt
fail to load bootargsParameters.txt file
Adjust Memory Allocation, dram_size=0x8200000, dsp_ram.start=0x8400000, dsp_ram.size=0x17c00000
crashflasg:1, logmagic:54410011.
Starting kernel ...
partition file version 2
rootfstype squashfs root /dev/mtdblock5
half-boot found, check bst
U-Boot 2010.06-svn5733 (Aug 12 2018 - 00:33:23)
I2C: ready
DRAM: 118 MiB
gBootLogPtr:00b80008.
spinor flash ID is 0x1940ef
partition file version 2
rootfstype squashfs root /dev/mtdblock5
gParameter[0]:node=bootargs, parameter=console=ttyS0,115200 mem=130M root=/dev/mtdblock5 rootfstype=squashfs init=/linuxrc.
TEXT_BASE:01000000
Net: Detected MACID:hide
PHY:0x001cc816,addr:0x00
s3l phy RTL8201 init
partition file version 2
rootfstype squashfs root /dev/mtdblock5
MMC: sdmmc init
Using ambarella mac device
TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'upgrade_info_7db780a713a4.txt'.
Download to address: 0x5000000
Downloading: *
Retry count exceeded; starting again
Try again use backup_serverip
*** ERROR: `serverip' not set
Failed to get info.txt
Fail to get info file!
Init error!
Using ambarella mac device
TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'failed.txt'.
Download to address: 0x2000000
Downloading: *
Retry count exceeded; starting again
Support backupVer:255
state:ff,err_count:03
Adjust Memory Allocation, dram_size=0x8200000, dsp_ram.start=0x8400000, dsp_ram.size=0x17c00000
fail to load bootargsParameters.txt
fail to load bootargsParameters.txt file
hmagic=0xffffffff
Before write boot backup version page, it should be erased!!!
SPI probe: 32768 KiB W25Q256FV at 0:0 is now current device
## Booting kernel from Legacy Image at 02000000 ...
Image Name: Linux-3.10.73
Created: 2018-08-11 16:38:49 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1570072 Bytes = 1.5 MiB
Load Address: 00208000
Entry Point: 00208000
Verifying Checksum ... OK
Loading Kernel Image ...OK
OK
partition file version 2
rootfstype squashfs root /dev/mtdblock5
fail to load bootargsParameters.txt
fail to load bootargsParameters.txt file
Adjust Memory Allocation, dram_size=0x8200000, dsp_ram.start=0x8400000, dsp_ram.size=0x17c00000
crashflasg:1, logmagic:54410011.
Starting kernel ...
partition file version 2
rootfstype squashfs root /dev/mtdblock5
half-boot found, check bst
U-Boot 2010.06-svn5733 (Aug 12 2018 - 00:33:23)
I2C: ready
DRAM: 118 MiB
gBootLogPtr:00b80008.
spinor flash ID is 0x1940ef
partition file version 2
rootfstype squashfs root /dev/mtdblock5
gParameter[0]:node=bootargs, parameter=console=ttyS0,115200 mem=130M root=/dev/mtdblock5 rootfstype=squashfs init=/linuxrc.
TEXT_BASE:01000000
Net: Detected MACID:hide
PHY:0x001cc816,addr:0x00
s3l phy RTL8201 init
partition file version 2
rootfstype squashfs root /dev/mtdblock5
MMC: sdmmc init
Using ambarella mac device
TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'upgrade_info_7db780a713a4.txt'.
Download to address: 0x5000000
Downloading: *
Retry count exceeded; starting again
Try again use backup_serverip
*** ERROR: `serverip' not set
Failed to get info.txt
Fail to get info file!
Init error!
Using ambarella mac device
TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'failed.txt'.
Download to address: 0x2000000
Downloading: *
Retry count exceeded; starting again
Support backupVer:255
state:ff,err_count:04
Adjust Memory Allocation, dram_size=0x8200000, dsp_ram.start=0x8400000, dsp_ram.size=0x17c00000
fail to load bootargsParameters.txt
fail to load bootargsParameters.txt file
hmagic=0xffffffbf
Before write boot backup version page, it should be erased!!!
SPI probe: 32768 KiB W25Q256FV at 0:0 is now current device
## Booting kernel from Legacy Image at 02000000 ...
Image Name: Linux-3.10.73
Created: 2024-05-22 9:02:31 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1584160 Bytes = 1.5 MiB
Load Address: 00208000
Entry Point: 00208000
Verifying Checksum ... OK
Loading Kernel Image ...OK
OK
partition file version 2
rootfstype squashfs root /dev/mtdblock5
fail to load bootargsParameters.txt
fail to load bootargsParameters.txt file
Adjust Memory Allocation, dram_size=0x8200000, dsp_ram.start=0x8400000, dsp_ram.size=0x17c00000
crashflasg:1, logmagic:54410011.
Starting kernel ...
partition file version 2
rootfstype squashfs root /dev/mtdblock5
half-boot found, check bst
I2C: ready
DRAM: 118 MiB
gBootLogPtr:00b80008.
spinor flash ID is 0x1940ef
partition file version 2
rootfstype squashfs root /dev/mtdblock5
gParameter[0]:node=bootargs, parameter=console=ttyS0,115200 mem=130M root=/dev/mtdblock5 rootfstype=squashfs init=/linuxrc.
TEXT_BASE:01000000
Net: Detected MACID:hide
PHY:0x001cc816,addr:0x00
s3l phy RTL8201 init
partition file version 2
rootfstype squashfs root /dev/mtdblock5
MMC: sdmmc init
Using ambarella mac device
TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'upgrade_info_7db780a713a4.txt'.
Download to address: 0x5000000
Downloading: *
Retry count exceeded; starting again
Try again use backup_serverip
*** ERROR: `serverip' not set
Failed to get info.txt
Fail to get info file!
Init error!
Using ambarella mac device
TFTP from server 192.168.254.254; our IP address is 192.168.1.108; sending through gateway 192.168.1.1
Download Filename 'failed.txt'.
Download to address: 0x2000000
Downloading: *
Retry count exceeded; starting again
Support backupVer:255
state:ff,err_count:04
Adjust Memory Allocation, dram_size=0x8200000, dsp_ram.start=0x8400000, dsp_ram.size=0x17c00000
fail to load bootargsParameters.txt
fail to load bootargsParameters.txt file
hmagic=0xffffffbf
Before write boot backup version page, it should be erased!!!
SPI probe: 32768 KiB W25Q256FV at 0:0 is now current device
## Booting kernel from Legacy Image at 02000000 ...
Image Name: Linux-3.10.73
Created: 2024-05-22 9:02:31 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1584160 Bytes = 1.5 MiB
Load Address: 00208000
Entry Point: 00208000
Verifying Checksum ... OK
Loading Kernel Image ...OK
OK
partition file version 2
rootfstype squashfs root /dev/mtdblock5
fail to load bootargsParameters.txt
fail to load bootargsParameters.txt file
Adjust Memory Allocation, dram_size=0x8200000, dsp_ram.start=0x8400000, dsp_ram.size=0x17c00000
crashflasg:1, logmagic:54410011.
Starting kernel ...
partition file version 2
rootfstype squashfs root /dev/mtdblock5
half-boot found, check bst
downloaded DH_IPC-HX5X3X-Rhea_Chn_PN_Stream3_V2.800.0000030.0.R.240614
I launched the TFTP server and only updated via UART:
- romfs, kernel, user, web, partition, custom
- (The bootloader was not updated)
Now when the camera loads, you can already hear that the sensor is triggered
Tell me how to revive the camera? Perhaps this is not a software glitch?
Last edited: