Sunba Tech 4405-20X 4K How map cable wiring to Ethernet

[rkruz3]

A rat chewed through the camera's cable right at the socket end, leaving no wire length to repair the cable.
I can splice in a new POE socket to the cable, but the 405-20X wire colors do not match the standard Ethernet colors. Can you tell me how to map the Sunba 405 wire colors to standard Ethernet colors?
The attached picture on the right is the Sunba 405 wiring and the left is a standard Ethernet cable I can patch to it to repair the socket
or
Is it possible to purchase a replacement POE cable for the Sunba 405-20X 4K? Thank you

 

[Broachoski]

If the rats left any wire on the cameras female RJ45 connector simply use an ohm meter and map out the colors for each of the 8 pins. I normally just use a punch down female connector for repair.

 

[rkruz3]

If the rats left any wire on the cameras female RJ45 connector simply use an ohm meter and map out the colors for each of the 8 pins. I normally just use a punch down female connector for repair.

thats a good idea. The rat chewed it off at the strain relief. No wire protruding. I tried unsuccessfully to remove the molded strain relief from the wires.