Hi guys. So done loads of searching and tried a lot of stuff but can't figure this out. Basically its as follows:
All passwords never changed from admin / admin
Was upgrading the Dahua VTO3211D-P2 to add SIP support
It wouldn't flash any of the firmware downloaded other than the ones in the package named Squashx
Flashed a few of these and version went up each time but still no sip options in web gui
In the end I though I will flash the back to v3.2 which it did using the squshx bin file, but I read this wasnt the one that was needed really so tried the others but it just rebooted the VTO each time I tried at 50% and failed.
At this point everything is working no issues other than I am no further on with my original goal of SIP support.
I decided to reset the unit with the tamper button pressed 5 times.
This reset the user accounts it seems and now the admin can't log in
I tried a full reset by pressing and holding internal reset ( done this a few times for different lenghts of time 5, 10, 20 secs)
It all reboots but still locked out of the gui and VDPConfig both say Login Failed or incorrect password etc.
The username and password before all this was admin/admin and that now doesnt work.
I have tried a load of other defaults but nothing lets me in.
Any ideas what I can do? The unit is powering up has defaulted to 192.168.1.110 makes all the right noises when it truns on and the GUI loads fine. Its also detected correctly in VDPConfig.
I just can't log in!
Thanks for any help
All passwords never changed from admin / admin
Was upgrading the Dahua VTO3211D-P2 to add SIP support
It wouldn't flash any of the firmware downloaded other than the ones in the package named Squashx
Flashed a few of these and version went up each time but still no sip options in web gui
In the end I though I will flash the back to v3.2 which it did using the squshx bin file, but I read this wasnt the one that was needed really so tried the others but it just rebooted the VTO each time I tried at 50% and failed.
At this point everything is working no issues other than I am no further on with my original goal of SIP support.
I decided to reset the unit with the tamper button pressed 5 times.
This reset the user accounts it seems and now the admin can't log in
I tried a full reset by pressing and holding internal reset ( done this a few times for different lenghts of time 5, 10, 20 secs)
It all reboots but still locked out of the gui and VDPConfig both say Login Failed or incorrect password etc.
The username and password before all this was admin/admin and that now doesnt work.
I have tried a load of other defaults but nothing lets me in.
Any ideas what I can do? The unit is powering up has defaulted to 192.168.1.110 makes all the right noises when it truns on and the GUI loads fine. Its also detected correctly in VDPConfig.
I just can't log in!
Thanks for any help