V5.3.6 problems?

C

Chaoscript

Getting the hang of it
Aug 11, 2015
212
10
Another one is upgrade firmware to V5.3.6 and have problems?
I have problems, like the camera is slow respond, the image is worst then before.
Camera model - DS-2CD2042WD-I

Regards.
 
One of the release notes for this fw state "optimization to the image quality". Not sure if your model uses the same sensor as my 4mp none WDR turret, but I thought the day images looked great on this cam so I'm guessing it was some night viewing enhancement, it may appear worse but perhaps better with moving objects, which the 4mp turret is horrible at.

Are your day images effected?

Here are the release notes.

http://overseas.hikvision.com/ueditor/net/upload/2015-12-08/f0817478-beab-42ac-93ab-c5bc6c7f5f41.pdf
 
NVR,
I don't know if the quality get better,
I just see that the cameras are stuck at Live view at NVR, the objects (car) are more speard on the picture.
It's was not happen before the upgrade.

Regards.
 
Here is video when I downloaded from NVR,
On the playback in NVR is very hard to see videos, it's stuck, the camera look "heavy" to load then before.
https://sendvid.com/n30a8nr8

Here is video that I record with CamStudio,
After I press the record button, I made refresh to nvr page,
You can see that the "back door" camera is loaded, but the time is stuck, the front door even isn't loaded,
And the third camera is Foscam, that didn't stuck.
https://sendvid.com/y1zkbe3x

Regards.
 
Last edited by a moderator:
Naturally you would want to revert back to your previous fw if you think thats the issue and if possible, I never mess with fw upgrades for these reasons, but someone else with more experience on this can chime in.
 
You must log in or register to reply here.
Top Bottom