Just for a little back ground I'm running 4 Hikvision Cameras all on 5.2.5 Firmware. All cameras worked properly on my old Super Mini NVR.
All the cameras have IP addresses of 192.168.1.x
The new NVR is on Firmware V3.0.7 build 140805 and Encoding Version V5.0 build 140704.
My network...
At this time I don't have a computer to adequately run blue iris efficiently. I looked into the software and it calls for an i7 processor and about 8gb of ram. So this is just a fill until I decide to either buy an NVR or upgrade my PC. Honestly I'm not sure of which path to go with yet.
Has any ever been able to get their Hikvision cameras to work with iCamSource that only uses the http protocol? I've tried just about everything with no luck. Any help would be appreciated.
Yea its about that time to do that. It's just hard to believe there are so much junk firmware out there for one camera and I can't seem to pick a single one that just gets this damn camera up and working.
Ok an update. I finally got the TFTP server to work and transfer the file however it stops on "Completed File" and doesn't complete the update. Now what? I've tried about 6 or 7 different firmware versions and they all do the same thing. I don't need anything custom I honestly would just...
A little back story:
Purchased the camera from Amazon. Got everything up and running smoothly. I was trying to configure the camera to stream through http and could only stream through rstp. The camera came installed with firmware 4.something. I don't remember. I figured I would go to the...