Recent content by BayAreaDave

While 2.01.03 is working for me, I have had flickering lines at the bottom edge of all my cameras that are in portrait mode while viewing on my iPad and iPhone ever since updating to the latest BI version 5.5.1.3.

Looks like that did it. Deleted the phone from Blue Iris and the then mobile app. After reloading the app and the phone, I am getting instant notifications again for the time being. Thanks for the suggestion. Edit Looks like issue not resolved. Still getting notification delays.

I just get the Blue Iris alert notification and open the app to view the motion clip.

I've noticed that the last couple of updates had partially something to do with Apple certificates. Someone commented over on Reddit that Apple recently made some changes to their push notification service. I'm wondering if these things could have something to do with it. I just find it odd that...

I believe the latest, 5.3.9.17. Sent from my iPhone using Tapatalk

Anyone else recently experience delays in receiving push notifications through the BI mobile app for iOS? Notifications had been almost instantaneous for me for about the last two years. However, I have experienced delays of 1-3 minutes both on WiFi and cellular over the last week or two. I am...

Depending on which cable route would be the least difficult, I would try to put it on the right or left side of your door at a height of about 5'. Since you have a narrow approach, I would also consider turning the lens vertically. I wanted a wider view, so I have mine set horizontally. The...

Actually, I haven’t sent the first one back. May be looking at what other camera I can replace. Sent from my iPhone using Tapatalk

I jumped the gun on assuming there was something wrong with the camera and edited my original post. I guess I got complacent with camera settings. I set up my other eight cameras two years ago with good images in the initial settings. I applied those settings to this new camera. The image is...

Thanks for the info. All of my 2mp and 6mp cameras have stayed between 4096 and 5888 with perfectly clear images. I kind of surprised that I'm having to adjust bit rate on this one quite a bit higher to clean the image up. I will give CBR and 8192 a try.

Will it fluctuate much under VBR? Should I use CBR to keep it at a set rate?

I had it set to VBR and the bit rate showed 2560. All my other cameras set to VBR with bit rates 4096 or 5888. Raising it up in intervals up to 20000 cleaned most of it up. I will lower it back down to a good spot

(Edited) I am definitely impressed with the better nighttime view compared to a IPC-HDW5631RP-ZE it was replacing. How do I clean up the blurred image?

I have about given up on stunnel and gone back to using a vpn. I have watched the video several times and have followed all the instructions. I have even tried entering the line sslVersion = TLSv1.2 as recommended by some to eliminate the need for a certificate. I also get the "The operation has...

I was also getting that error. Not sure if it had any correlation to my daily crashes.