Recent content by Benak

they are for 3.5"... sorry missed that. So these are the screws from the other thread here? I'm putting a g2 600 together right now & just opened the case - I need to sort this out too for a 2.5" SSD I'd like to mount in the lower tray as a boot disk

I think they are here on Amazon, they are proud of them for what they are

+1 for HP from me, I have an old i5-3470 HP that's never missed a beat to this day and I can't remeber the last time I turned it off. I have had a few minor hardware issues with optiplex machines over the years (I still own four personally though.... not sure what that says about me?). The HP...

This machine has a free M.2 slot so I would of put a 256GB or so M.2 SSD in it to boot from/run the OS, further this application is only for a few 1080p cameras, 1 or 2TB of storage is fine for the use case. To that end, I've seen 5TB mechanical 2.5" drives on Amazon (never had my hands on one...

Thanks Fenderman, I can get this for less than $100. More than anything I'm curious about 2.5 drives, never considered that form factor for NVR duty. I actually had an 5th Gen i5 SFF Optiplex I was going to buy local too (as opposed to this micro) but the seller backed out for some reason...

I am getting ready to deploy a new BI system and have the chance to buy a Dell 3020M local to me with a i7-4785T & 16GB of ram on the cheap. The chassis doesn't have a 3.5" drive bay, only 2.5" in addition to M.2 that I would put the OS on. So my question is is there a 2.5" drive that is...

Thanks for the feedback bboy. The way I read the instructions was that you needed to have the camera paired/synced in the Wyze app before attempting to flash the new beta firmware. I think you're saying you paired the camera in the Wyze app at the same time as flashing the new firmware? I'll...

I wasn't able to get the beta firmware to flash last night after screwing with the camera for 45 minutes +/- Has anyone else had issues flashing this firmware? I'll probably try again on the weekend. Currently have firmware rev 4.19.4.48 installed. I've seen some rumbling on other forums...

There is a link here: Wyze Cam RTSP Works with v2 only or Pan - I have v2 and will attempt to get this in operation with BI tonight.

I bought one for the same reason, the best luck I had was putting the camera on it's own separate wireless AP that I had laying around. Kind of a lot of hassle to implement a cheap camera.

As I understand it night mode isn't working with the custom firmware.

Pretty sure they are 10 watt, 10 ohm

All a good idea, the two cameras I played with were trying to "phone home" always... I can't remember specifics but they are installed on an isolated network so not a big deal.

I can't answer your question directly but I would get the camera off any internet connected network ASAP. You should have been able to connect to the camera's built in web page by assigning a computer to the same subnet and pointing a browser at the factory default IP address. The static (or...

I quit playing with it for a bit but I can set it back up and get some footage posted... Just need free time