Recent content by danli

Thanks for the Support David. But after spending some time trying to get it up and running, something is definitely wrong with the device. It is a bit unfortunate, because even though it was not the perfect device - it was good. I had it connected to openHAB via ONVIF, and it supported...

If I try to add it via the "lower frame" it says, "access denied". If I try to add it via the + on the upper frame it says device offline. I will let it rest unpowered until tomorrow, and see if the situation improves when I have a bit more energy. (It's 11 pm in Sweden right now) Thanks for...

Ok, if I connect a computer to the doorbell AP, and start batch config it looks like this what is the next step? (everything I've tried so far failed)

I realised I can actually connect to the doorbell via the HIK Connect app (manually via IP) , if I connect to its AP and add the IP it allocates (192.168.8.1). I can get a livestream. But I cannot for the world understand how to set it to connect to the wifi network. I have read the 101 page...

Hi all, My Ezviz DB1 has been running fine for, maybe two years by now. However, this afternoon it lost contact and went into AP-mode. It does expose an AP softap_serialno. (yes, I flashed the hikvision firmware to it). Since it's been so long since I've touched it - I have forgotten every...

That is a good idea. But I had the vision that the rest of the family should be able to just eyeball the cameras and get a visual confirmation that they are not recording, or actually not even able to record. An alternative could be some sort of ptz camera (like a dome, but without the actual...

Hi, I am considering ending my contact with my (connected) home alarm. The supplier have been raising the price every year, and now to point that I feel it is too expensive. In the alarm installation I have a few indoor cameras directly connected to the alarm central. Outdoors I have a numbers...

I do get a video stream when someone is pushing the button. Hik firmware and hik-connect

As of Today I can no longer log in to the EZVIZ app using my hik-connect credentials. Too bad, since I preferred that app. So, for now on I'll obviously use the hik-connect app...

Probably. But I guess that putting the stream into a container accepted by Chromecast and filling up the streaming buffer adds to the "delay"

Since you obviously already run openhab, just link the camera to google home via openhab and the ipcamera binding. It's pretty straightforward. Also, via openhab I get a delay of approx 7 seconds on the videostream (to any Chromecast device or nest hub) as compared to 30 seconds using ezviz...

Yes, I have tried it. Did not notice anything revolutionary. It still does not do image deskewing. That feature is the reason for me to continue use the ezviz app.

Anywhere between the transformer output and the doorbell is fine. The fuse still sits on the same wire.

1. 12V. 40VA 2. I have placed the fuse right at the transformer output.