Recent content by Dinar Kamat

Thanks civic17 !! I cant manually add them. Looks like Hard reset is the only solution.

Thanks for all the info !! Wish there was an easy reset button as opposed to opening the camera n all.

This is the first time they are connected to the nvr and the prewired wires. All 3 of them were bought new. So don’t get why the login error is showing up. If hard reset is the only solution i will get someone take a look at it. Thanks again !!

Thanks for this info. But my camera's are installed on 3rd floor and it will be really hard to climb up and do all of this. Is there any other easy way to do the reset other than doing a hard reset ?

another image

Matt I didn't plug the cameras into the NVR I just plugged the network cables into the NVR. May be I am not using the right ports. Southeryankee:- I got the camera's and nvr with Matt and EMPIRETECANDYhelp sometimes back but didn't get time to install them. No the builder didnt set up the...

Thanks for your response. IPC-HDW5231RP-ZE are the camera's NVR4108-8P-4KS2 is the NVR Its pre-wired by the builder poe connects one end to the camera and other end is to the nvr I dont think i tried the camera's on my local network Where will I find the PC, NVR and route internal IP address ?

Hi, I just got camera's installed around my house. Its POE camera's. However I can only see 1 active camera. See attached snapshot. Any pros can you please help me as to what I should be doing ?? Thanks in advance !!

Thanks so much for this info !! That helps !!

when u get the camera out of the camera mount bracket its hard to put it back and only goes back in an angle.

finding it hard to mount the camera. It doesn't fit it properly in the hinges. Is there a trick to do it ? Didnt find any installation videos online ?

Hi, Is there a video with detailed installation steps to mount this with PFA137 ? Instructions in the box are not very clear. Thanks !!!