Recent content by EagleEye7

  1. E

    ALPRFast — a CUDA/Linux CodeProject.AI ALPR module (fast-alpr) tuned for wide 4K overview cams

    Have you got BI itself on Linux?
  2. E

    What is the best way to "Pause" the trigger of a camera for a few seconds?

    Have exceedingly low-grade LLMs hijacked this thread??
  3. E

    Forum technical problems getting bad?

    Right.
  4. E

    Forum technical problems getting bad?

    How does AI nonsense have any link to forum technical problems or whether the forum is toast or not?
  5. E

    RF Detector?

    Also, are there any peripherals (e.g mouse) plugged directly into the NVR? Might be worth testing with them unplugged in case something as silly as a faulty mouse.
  6. E

    RF Detector?

    Interesting. Had you started the above mentioned test yet at this point? Was the NVR recently connected?
  7. E

    RF Detector?

    Hmm. Let's run a test. Reset the NVR back to the overview screen. Leave disconnected from the Internet completely. Monitor for a week, see if it's stable. If it is, then connect it to the Internet for a few minutes, disconnect and monitor for the next 24hours. If it again goes weird after, and...
  8. E

    What the Heck?

    What a disaster of a vehicle. :screwy: :smash:
  9. E

    RF Detector?

    Yep, LT2P by itself is very useful for tunnelling, but not encryption!
  10. E

    RF Detector?

    Certainly do this. Just to make 100% sure. Very likely because your L2TP server listens on UDP, but the scanner is only scanning TCP. Scanning UDP is hard, actually. Side note, is your VPN plain L2TP or L2TP + IPsec?
  11. E

    RF Detector?

    Looking good. Are all the blocks green, screenshot has cut of the ports lower than about 160 which are some of the most important to check.
  12. E

    RF Detector?

    You have run a UPnP scan. That's good, but the other half of the test is a port scan. Instead of pressing the big yellow instant UPnP button, press the All Service Ports button, and post that result.
  13. E

    RF Detector?

    You shouldn't need to be proficient in networking to run some of these steps, especially this part: https://ipcamtalk.com/threads/network-security-questions.82365/page-4#post-991257 If you are struggling to interpret the results, just post them here. What AV are you running on your PC (and...
  14. E

    RF Detector?

    So when you do make adjustments or check footage, you're plugging the NVR into your network, rather than directly into a laptop? Or you have been up to now? Were you able to perform some of the steps I detailed in your other thread, regarding your network? I'm not to completely divert this...
  15. E

    RF Detector?

    Any odd equipment behaviours?
See more
Top Bottom