Recent content by Gwladok5

I'm very grateful, thanks

Hi! I've just brought the firmware up to date on my DVR & its asking for the verification code on various devices. I've sorted the ipad & smartphone but the Windows application is telling me to go to the modify camera interface to set the encryption key. Can anybody tell me where this is on the...

I think we are getting somewhere. I've taken the 4k tv upstairs & connected it to the HDMI direct - no issues. This is the hdmi/ethernet converter: wyrestorm ex-40-g2 I think it only supports 1080p maximum? The DVR output is 1980 x 1080 which is 1080P.? Installer is booked; as I'm thinking...

Hi! Sorry for being so long to reply. My existing setup is the HDMI from DVR to a powered HDMI splitter, one hdmi going directly to a tv in the bedroom which works fine, the other hdmi output goes to an ethernet converter then down to the main tv (through another converter. I've just bypassed...

I was wondering if anybody might have the answer to a problem I have. Although all my cameras are set to 1920*1080P, I have to set my DVR VGA/HDMI output resolution to 1280*720/60HZ otherwise my 4K TV picture will keep flickering on & off if I try to match the resolution of the cameras. Anyone...

Hi! I've had my CCTV system in now for about 6 mths. I've got 6 x DS-2CD2142FWD-1 cameras & the DS-7608NI-E2-8P NVR. As with everyone else I've been messing with settings since the installation! Firstly the daytime picture quality is outstanding, however its the night-time where I struggle...

After changing some settings, I've now got this message when accessing the Linkage settings: Please confirm the event output in "Live View" settings menu is the same with the real event output. Could someone point me in the right direction to correct this? Thanks

Hi Jack B Nimble, would you mind if I asked you for some more advice? I would like to try to get my cameras to play back at the same quality as the live view, or at least have the recording play back as smooth as possible. Can I show you the current settings on one of my cameras to see if I can...

Just to let you both know that mine is now working a treat! Full access to all settings through my PC.

I'm very grateful for your help; I've just been able to reset a faulty camera!!

Hi! I've just installed SADP version 3.0.0.2 build 20150911. It brings up the NVR but not the cameras. Virtual host is enabled. The NVR is DS-7608NI-E2/8P & the cameras are DS-2CD2142FWD-1 Am I missing something?

I've got a problem with my CCTV system & wonder if someone can help me. Firstly, I've got the Hikvision DS-7608NI-E2/8P NVR with 5 x Hikvision DS-2CD2142FWD-1 cameras. I've recently upgraded the firmware on the cameras from V 5.3.8 Build 151224 to V 5.4.0 build 160401 then to V 5.4.1 build...

Hullo The NVR is Hikvision DS-7608NI/E2/8P & the camera is DS-2CD2142FWD-1

Can anyone help me out? I've got a yellow warning triangle bottom left of my screen indicating "Resolution or Bitrate of substream not supported" Although that camera appears as normal on my NVR direct feed, it does not show on my PC, smartphone or Ipad apps, although it does during night...

Just to let everyone know that my camera upgrades were successfull. **ONE WORD OF CAUTION** You need to hold your nerve when going from 5.4.0 to 5.4.1; the camera reboots take quite a while before the upgrade is applied!!