Recent content by hinzinho

Alastairstevenson, I got my hikvision cam up and running today! Today, I have some spare time and thought I would give it another "good old college try". I ran your commands again but it was still giving me a lot of bad block errors. With nothing else to lose, since this camera is a goner, I...

I have followed the commands from the 2 posts. I spent most of my time trying to get the mount working. I ended up using this command 'mount -t cifs /192.0.0.128/temp /mnt/nfs00 -o username=myuser,password=mypassword'. Toward the end, when flashing the mtdblocks, I got a lot of errors. Only one...

I have downloaded 5.2.0 firmware as suggested to my tfpt directory. When I issue the 'update' command, it just stay stuck in that mode. I don't see any activities in the tfpt log or in wireshark. I waited for at least 20 minutes before giving up. . HKVS # update I figured maybe it doesn't...

I have provided 2 different scenarios. One with the network cable plugged in and another without. I checked with WireShark and SADP Tool and don't see any activities from the camera beside the initial tftp check from WireShark. With the network cable plugged in. I left it on for about 20...

Below are outputs from the terminal. I ran as much commands that I think was useful. There is one command, "upf", that similar to update, but I don't know what this mImage file it is looking for. Thanks again! HKVS # help The following commands are supported: boot help bios diag mtest...

Took a while to get the parts but I finally got it! I have terminal access to the camera. However, I still don't know what is the issue or the fix when I am in the console. I ran tftpboot and it is able to grab the digicap.dav file from my tftp server but I never get the "Device [192.0.0.64]...

Thank you for the replies. I tried redoing the tftp process multiple times and each time I can see the message "Device[192.0.0.64] test tftpserver" but never get to the "Connect client[192.0.0.64] success" step. If I have to use the serial connection to restore the firmware, are there any good...

It doesn't detect it. I think my camera is in a limbo stage since I loaded the brickfixV2EN image but have not completed the telnet part & loading of the HikVision firmware.

Hi, I have a DS-2CD2532F-IS camera that is bricked. I loaded the brickfix with tftp and it completed the process and I got the "System update completed" message (step 5 of your instruction). After I did a power cycle on the camera, I can't ping or telnet into 192.0.0.64. My computer is at...

Hi, I am new to BI. I am replacing a Q-See NVR that has failed (this is my 2nd unit from Q-See and both experienced the same issue). I have the following setup: 3 cameras : - Q-See QCN8004B 1080p bullet IP camera 1 PTZ camera: - Q-See QCN8035Z - PTZ camera (this one is not online yet as I...

I got it running now. Thanks bp2008 for providing us with the old installer.

Same here. Reinstalled multiple times and still getting it. I am on Windows 7, testing version 4.4.9.9 as a demo.