Recent content by josalamanca007

The brightness could be due to auto settings like you said. I tried to get a better seal tonight but I made it worse, I will take it off tomorrow evening and try again.

This is the way it looks without the dome cover and IR on.

It's probably worth comparing, I am going to take it off and share a picture.

Here are the night shots. No IR: With IR: Looks like IPC has a good seal with the gasket, but has some sort of circle in the image which is caused by the IR, not visible without IR. IPC2 doesn't look like it has a good gasket seal, IR still bleeding, not as much as before but still.

To recap. 1. Camera was left open for over two days. 2. Lens rotated so that most of the IR led are on the bottom. 3. Latest firmware. 4. Camera is installed under soffit about 12ft. 5. Everything set to default. 6. I used a little foam between the gasket to create a better seal. 7. I found a...

Hi all, thank you for the replies. I have the latest firmware. I will re-install the camera on its intended spot and share some night shots today.

I was able to use foam and raise the gasket a little bit a create a better seal: I see improvements but not clear enough. The dome and lens were cleaned with a glasses' cloth. I am not sure how @looney2ns got nice night shots and didn't have any issues with the gasket. I will probably have to...

Thank you for the quick response, I can see that the gasket is not sealing against the dome. What type of foam could be used to get it to seal ?

Hi all, I recently bought two IPC-HDBW5441F-AS-E2 (2.8 and 3.6) at night both of them appear to suffer from ir reflection. Today I decided to unmount them and test the the lenses pointing straight out. Thinking the issue was related to having the lenses in an angle. With the lenses like this...

This worked for me on a Cisco 6030. rtsp:/192.168.254.134:554/StreamingSetting?version=1.0&action=login&userName=admin&password=password&getRTSPStream&ChannelID=1&ChannelName=Channel1

Just in case anyone else wants to schedule a reboot of the doorbell camera, this is what I am using to reboot it: curl -X PUT --user admin:password http://192.168.0.64/ISAPI/System/reboot and if you want to reboot the rest of your Hikvision cameras, the path is...

Just want to share, maybe it helps someone else. I have the LaView version of the camera, flashed with Hikvision version of the firmware. Sometimes my camera would go offline and only a reset or re-enroll would get it online. Today I decided to log on to Hik-connect.com and check out the...

Any idea if there is a way to disable the "ding dong" upon cold boot? We had some bad storms last night and I had to put some cardboard on the chime to stop it from waking me up. The rest of my camera setup runs on POE and has UPS.

Thanks, I will probably try the Hikvision.

How has anybody been able to get the firmware file from LaView, I've searched this thread and seen folks share the dav file via drop box(old versions of LaView door bell firmware). I would like to try the a different firmware, like the one from Nelly with the different wave audios, but would...