Recent content by Klaus Schmidsrauter

I got the cameras working today, but I am still totally puzzled as to the initial cause - all I can think of is a software glitch in the NVR. 1. My "bad" channel was channel 2 (POE port 2) - channels 1, 3 & 4 were OK. 2. I rebooted the NVR again - no difference. 3. I cycled the AC power to...

YES, those are correct, too. Port 888 is listed for ONVIF and configured that way in both NVR and cameras.

YES it does. I made sure when I first installed the system. The actual camera IPs and ports match what shows on the camera management page of the NVR. IPs 192.168.254.11 - .14 and ports 65001 - 65004.

YES to questions 1, 2 and 4. The log showed no unusual entries from July 1 to July 31 except for "IP Camera Disconnect" - D2 on July 17 at 07:36:01. Then I swapped camera cables around amongst the channels and the others showed "Disconnect" and then "Start Record" as they came back up - all...

I'm installing a Hikvision DS-7608NI-E2/P8, firmware V3.4.95 (english) with 4 POE Foscam bullet cameras. I had everything working perfectly for 2-3 weeks but then, all of a sudden, Channel 2 stream disappeared. In the Configuration, that camera shows as "Offline (Network Abnormal)" and nothing I...

I am connecting via the 192.168.254.xx IP addresses to access the cameras' web gui for configuration changes and that accesses all features of the Foscam cameras. The video streams will be recorded and viewed on an HD monitor connected to the NVR and any staff that wants remote viewing will be...

Hello Alastair, you have solved my problem. Thanks again for presenting the 3 requirements so clearly. I tried a couple things, based on your "static route" point: 1. Added a static route to my laptop's routing table, with the laptop connected to the NVR's LAN port - cameras on POE segment are...

thank you

Thanks for the reply Alastair. I've already found some of the info you mentioned by reading some of your other posts. The first 2 items in your reply I had done already. I also tried port 80 on the cameras, but that made no difference vs other ports, including the 650xx range. To try your 3rd...

Does anyone know of a way to access the Linux embedded in this NVR? Being able to get to the Linux command line might enable me to check and/or modify the Virtual Host function.

I have just acquired this NVR for our church and I cannot get the Virtual Host to forward the camera web interface to our LAN. Firmware is V3.4.95 Build 170228 has the Virtual Host feature and I have it enabled. The internal POE segment is the default 192.168.254.xx (Foscam FI-9901 EP cameras...