Recent content by lcam

After hard resetting it with the reset switch then the IVS started working. Thanks for everyone's help.

Okay. That is a pain since the cameras are on a VLAN and resetting them will cause them to go back to a default network but I will try it and see what happens. Thanks. UPDATE Okay I set it to factory settings, updated the firmware and setup IVS and there is still no alerts working. Do the...

In the IVS tab? No but this is also unchecked in another camera with older firmware and it is working.

No, should I?

I have a few of these cameras and I use them with BI. Recently one starting detecting motion all the time and I kept finding the video detection checked which I don't want since I use IVS with people and car detecion. I upgraded the firmware to the one dated 2023-12-21 which I downloaded from...

Thanks for your assistance.

Okay it does seem to auto track with the MD and SMD off. I don't know why it wasn't working before. I do see MD enabled again after I log back into the camera so you are saying that BI will enable that? To fix that I think you are saying to go to Video Detection > Motion Detection > Area and...

It sounds like you are saying that I need to turn off MD and SMD. I have a intrusion box drawn on the Deep IVS tab so is that what you are talking about as far as the square in the corner? Should I add another intrusion box other than the one I am using?

Does anyone see what I am doing wrong in this setup?

Nope, when the SMD is checked I get false positives.

Okay here are my settings: With these settings the auto tracking does not work. If I check the box on the motion detection tab then it auto tracks. I'm testing now to see if checking the SMD allows auto tracking and no false positives using ONVIF.

I have 2 of these cameras and the auto tracking works pretty good. I am using this with Blue Iris and motion triggers setup in BI. I want to make use of the IVS and ONVIF triggers in BI to help eliminate some false alarms. When I leave the settings alone in the camera and enable the ONVIF...

Thank, That's good to know. We just had the house built and I could have selected where I wanted additional Cat6 cables and I didn't pick the doorbell because I didn't know about the POE option. I can probably get a cable there but I'd rather not at this point.

Great! Thanks the the information. I'm not sure I can get a cable to the DB so I plan on getting the WiFi version so I hope it works the same.

I was thinking about getting one of these Wifi DBs and want to use it with BI. I read/skimmed most of this long thread but I don't think I read about anyone using this camera for triggers in BI. I know in the past that Reolink cameras don't work well with BI because of the FPS/Key issue but I...