Recent content by MAHV

I found your detailed post here: Hikvision Doorbell and OmniPro panel to Elk 960 and Current sensing switch - HomeSeer Message Board With "so now trying to use powerkit over relays" I mean that if you can use the powerkit parallel on a mechanical chime, it should theoretically also work...

Can you please elaborate a little bit more on you hardware setup indicated by "Relating to a physical push on the doorbell button and chime connection this still works just fine. Digitally here using a current sensor and debounce circuit board to the alarm panel zone which triggers chime sounds...

Thanks for reply, according to step 9, @misally is convinced that EZVIZ firmware is running on the doorbell, and that simply by adding a new user (step 10, apart from admin), the ONVIF functionality is working.

Oops, so I should revert to previous version or indeed block web-access. If you're right, this also means that someone from outside has installed different firmware without knowing my strong password on both cams. Sounds weird.

I would like to get this working on EZVIZ DB1, but can't find EZVIZ firmware 200321, I can only see 200220 or 211011 as latest firmware. Also it looks like you've got EZVIZ firmware working with ONVIF, although page 101 states that EZVIZ firmware does not support ONVIF functionality. Can you...

With respect to log: I do not intend to try it again now they are working again ;-) They are mounted on an outside wall again, so resetting is a bit of a hassle. Firmware: V5.4.5build 170123. Remains strange this happens after 4 years of good operation for both cameras at the same time and I...

Today I've gone through your procedure to change firmware for EZVIZ DB1 to Hikvision's firmware. A few things were different, indicated below for each of your steps: 2. Good to know that Username=admin and Password=<Verification code> 6. Reboot did not work, I had to disconnect the power to DB...

Just want to share solution I discovered to circumvent a bootloop that suddenly happened to two cameras at almost the same time (after 4 years of good operation). They both boot until the IR-leds light up, after which the device reboots. Initially I thought a power/cable failure would cause the...