Recent content by Ozzie238

I had to open camera up and find tiny button, and presto, up and running. I did try the configtool before I opened it up and I did see option to reset password, restore, etc. neither method was allowing me too continue. But anyway it’s working Thanks again!

Thank you I’ll give that a try

Hello everyone, I’m stuck trying to find the password to change IP address to be within range. Camera can be seen in configtool, Where I can see cam IP address. I type in IP address in explorer and no go. I click on explorer logo in configtool for camera and I then can see dahua menu to enter...

With your help and guidance, 2 of the 3 cameras are working. Thank you very much!! The one camera that isn’t working, I hit the reset button, following another lead. I’ll worry about that later. What got me over the hump were these steps found in post. -plugged one camera at a time to router...

Yes, The dahua nvr software is giving the error msg, I’m not using any other software/program. Dahua cameras are ipc-hfw1431sp which I got from Andy. When I first did the ping for the IP address You suggested it was plugged straight into the router where it didn’t detect camera. No switch...POE...

PC 192.168.1.7 Router 192.168.1.1 Netgear n600

So after ping 192.168.1.108 When cam not plugged into router, I get destination host unreachable When cam plugged in I get same results.

Thank you, I did purchase camera through Andy. But I’m still having just about the same issue with error msg of conf.loginerrorno.18 I’m trying to go through cliff notes but no luck.

Any site / seller you recommend?

Wow. Okay. Looks like I’ll be doing that. Thank you

hello all! I’m glad this exist. I need help, I’ve searched around even got Help from authorized seller where I purchased cameras. The cameras I acquired are 3 dome IPC-HDBW4433R-ZS models I followed another threads lead and went outside and reset each camera, held button for 20-30 seconds. It...