Recent content by PajamaGuy

Great! Concise, straightforward, and polite. Thank you!!!

...from page 48 "As it is possible to define multiple zone maps, perhaps for different active profiles or for recently used PTZ presets, and it’s possible to invalidate the zone map using PTZ movements, the currently active zone map is identified for your information on the bottom of the...

Try going into the 8910's web interface, click "defaults", in-check flip & mirror, delete it from BI and try again. Or use the 8910 interface to reset to factory.

Camera set with 10 sec pre-trigger, 1.5 sec make and 30 sec break. Works fine. I take my dogs outside (forgetting to change profile), trigger camera and it records until 30 sec after motion stops. A couple of minutes later, I re-enter the zone but the camera does NOT trigger. There must be a...

Thanks to you'all for the help, especially for the How-To videos, and the advice to get an 8300 from Ebay! Bought the HP-8300 refurbished for $200 with 64bit Win 10 Pro, 500 GB hard drive and 8GB RAM. Dropped in my own 3TB drive for storage. Your advice was right on! I've watched several of...

Ok, I bought an 8300. Now help me with the dwell time - or should I delete all presets and start over? And then point me to where I can find how to set up a periodic patrol (every 15 or 30 min), and take a snapshot at every stop on the patrol. Thanks! (The direct-to-disk cut cpu to 35%)

Its only job is BI. That said, where do I get the used HP or Dell?

OT - anybody know why I can't "WATCH" this thread?

Processor Intel(R) Core(TM)2 Quad CPU Q9300 @ 2.50GHz, 2494 Mhz, 4 Core(s), 4 Logical Processor(s)

The RAM's because with more cameras I get Out of Memory and there's only 4GB. The CPU's ok, and yes I did NOT have Direct to Disk selected. Thanks! PJ

I've read most of the Help, and I've watched the videos (Thank-YOU!) Dasstrum), but there are some answers that still elude me. Although I have 15 cameras in two locations, I've had to cut the .REG files down into small groups of cameras until more RAM gets installed. So the current .REG has 2...