That actually sucks ( if it is true )!!
because then you loose all the extra features you can set on the local device that are not available on the NVR
At first setup I used the NVR to do the initial setup ( motion & intrusion detection ) with automatic IP through the NVR
Now I switched to a fixed IP address for every camera.
How Do I discard the motion detection/ intrusion detection on the NVR and Use the local camera settings ?
If I check...
Looks like an external POE device fixed this issue for me, no more pan tilt zoom initialize failure at startup
When connected to the NVR with a short cable = OK
When connected to the NVR over a +10 meter cable = NOK
When connected to a external POE device + cable over 10 meters = OK
The Cameras have a IP address now and connected to the NVR.
Do I configure the camera directly ?
And does the NVR just do the recording or does the NVR overwrite the settings on the camera ?
It is so strange that I have the option to configure 2 devices, the camera and the NVR ...
I upgraded to firmware 5.4.8 and auto-tracking is not available .
Is there a way to downgrade ?
Does somebody has the firmware with autotracking ?
Regards
I had another run over this tread and I come to the conclusion that there is much more to do with these camera's if you give the camera a IP address instead of using the auto plug & play from the NVR.
Not much settings you can do from within the NVR menu.
just a example
Auto tracking
more fine...