Recent content by rajuabju

I have a bunch of Dahua HDBW4231F-AS Minidome camera's which are EoL but have been pretty good (these are used for interior only situations). I need to install several more mini-domes, and want to know what model number I should be looking at? Must be PoE, needs to have microphone for audio...

Thanks for feedback; Confirmed both cams on H264, Smart Codec off. Also tried just Intel (no VPP) for the decode. I do see the firmwares are different (the one where HA is NOT working is actually a newer firmware) between this and other camera's. I will need to see if I can downgrade and if...

I have 22 total Dahua Camera's, about 15 of which are the IPC-HDBW4231F-AS mini-dome's No matter what I seem to try, there is ONE of these cam's that doesnt seem like want to use hardware acceleration; when I look at the Blue Iris status page, every camera has an I or I+ listed except for this...

I need this. Not sure for what, but I need it.

I’m using Dahua mini domes and love them. Have a bunch in the house covering stairs and hallways.

All 21 of my Dahua cams work great on the BI app for my iphone 11pro max running the latest version of iOS (see what I did there)

Really strange indeed. I will try again holding the reset button for 1+ minute to see if it can just stay on the .1.108 address instead of the loop. I'm also on a Unifi network setup. I've even tried moving the camera to a different port just to see if it was the switch acting up but not. Maybe...

I dont know whats going on, but as of yesterday, I have a Dahua mini Dome Camera (HDBW4231FP-AS) doing the exact same thing... the normal static IP for this particular camera is 192.168.245.4 ... it will go to that IP, then switch to 192.168.1.251 ... back and forth in a loop, not long enough...

What a great thread that has been resurrected. I had always left my Audio settings as the default on my Dahua cams, but looking into this thread now, AAC encoding is available on all my Dahua cams (mix of Domes, Turret & Bullets), which is a superior codec to G711. I also turned off noise...

So far so good. All cams but one working as expected. Still troubleshooting the one camera but I’m getting close. Thx for the feedback and help so far!

Well, so far its been 22 hrs, and everything seems ok. Per some other recommendations, I tweaked a few things, as follows: 3 of my 20 camera's did not have DTD enabled, so I fixed that. I also tweaked frame rates from the camera's to lower slightly. Updated all drivers/firmware on my...

Yes, switch is on a UPS. Its the Unifi 48port 750w switch. So it has more than enough power. I can monitor draw for a few days. But not sure I understand night vs day question, the "No Signal" issue I'm experiencing isnt tied to a specific time frame or time in the day/night, other than it...

Got it, thanks for clarifying. Yes, BI Computer is on same switch as camera's. No, when tracing network path, it would go Camera <-> Switch <-> Computer (and the WD Purple hard drives where everything is stored are inside the computer, not using a separate NAS)

Yes, separate LAN (and protected by VPN per recommendations here) Not 100% sure what you mean by data pass through router? its through my switch. I have a Ubiquiti Unifi POE switch for all camera's. I will check my other switch and and see if I can swap Screen shots attached. Everything is...

So far, Official BlueIris support hasnt been much help at all to me. Every 2-3 days, I am getting a "No Signal" error suddenly on ALL my camera's. Not really sure what is causing it . All of my camera's (20) are Dahua brand. Mix of bullet, dome and turret. They are all POE camera, all of them...