Recent content by Schmark

So, I am going VERY slowly. Starting with 3.4.98 I did the following step-wise downgrade/upgrade: 1. Downgraded to 3.4.80 - OK 2. Downgraded to 3.4.6 - OK 3. Downgraded to 3.4.0 - OK. Did not have the courage to further downgrade to the 3.3.x versions. Any bricking risks going to 3.3.x? 4...

Alastair: Any chance I may brick the NVR by reverting all the way back to 3.3.4 (4 years ago)?

Thanks gregfooyong and alastair. My NVR is an E-series and was delivered with FW 3.3.6 Question: is it safe to revert back to 3.3.4 from today's version 3.4.98 ? I have counted 16 intermediate releases since 3.3.6 . . .

Over time, I did upgrade the FW on my NVR, but usually to the latest version, sometime skipping intermediate versions, especially if a long time elapsed since the last upgrade. Is version-skipping OK or should I religiously go through every released version since the last upgrade? I sort of...

Mode B makes sense as it shows Tx and Rx on the same wire pairs. To go one step further, is there documentation showing packet content? I am interested how command, Main stream, and Sub stream are interleaved (and marked).

Fenderman, I wired my system with T568B. Would you know which mode (see below) is used by the Hik cameras/NVR?

Fenderman, are you saying data AND commands transit on the same wire? Is there some document/link describing what passes where? -S

Cabling between IP cameras and NVR is Ethernet 8 wires. Commands go from NVR to Camera and data goes from Cameras to NVR, supposedly on different wires. Is there a link showing the content of the command and data packets that are traveling on the cable? For example, are Main stream and Sub...

Can't locate the url, yet a ping of that address yields positive returns. See below both curl and ping commands.

I tried ODM again, but I still get the same error message I showed on message #13.

I rebooted remotely (Configuration>System>Maintenance) and now I get the screen below, which is now the same screen you show in message #24.

I created the xml file using Notepad++ and after I changed both authentications (RTSP and WEB) to digest/basic from basic, I get what's shown below. Do I need to reboot the NVR after changing the authentications? If so, it will be when I get home in a few hours.

Windows PC (windows 10). Interesting that Restlet was installed with 0 requests allowed. It also appears the quotas will be reset to hopefully other than zero later today at 17:00 (though not sure what time zone)

Still no response, even with Host unchecked. BTW, thanks for not giving up.

Thanks bp2008. I installed the 32-bit version of Pale Moon and it works as well as IE11. However just like IE11, I cannot see any Main Stream when I go full screen for each camera. Perhaps the problem is elsewhere? -S