Recent content by tommyd75

Yes mine is set for human detection and I have drawn the orange lines but it’s picking up humans farther away from my drawn lines. I don’t think that “motion detection area” works when we are using the human detection option. I have it at the lowest sensitivity. Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Actually I can’t take credit for it I found the idea looking for a solution to activate a relay once the button has been pressed and found myself on a konnected forum. Here’s the post. https://help.konnected.io/support/discussions/topics/32000001411 From the post “Sam” drew a nice simple...

I just installed one of these to mine and it works great. It basically is a current sensor. You just separate one of the leads going to the doorbell and run it through this. It has a N/O contact on it. You can adjust the sensitivity with the little adjustment screw on top. I had to take some 18...

Thanks I’ll just keep using it on VPN. I agree about exposing it, my Ubiquity Gateway must be blocking something else. Sent from my iPad using Tapatalk

Both. When I connect via the VPN or on Wi-Fi from within the house it works fine. But when I disconnect from Wi-Fi or VPN and just connect via my phones LTE I get a couple of scones of live video then it freezes. I had tried opening the ports like the 101 says bait that didn’t help. Sent...

So I’m still having this issue. I have tried forwarding the ports listed but still didn’t help. I can access it and get live video when I’m on Wi-Fi or connected to VPN but not outside of the network even with the port forwarding. Is anyone else seeing this behavior? The ports I have added for...

Here’s something I’ve noticed with this doorbell camera. I’m using the EZVIZ app and if I’m not connecting via WiFi from inside the house my live view connects but then freezes the image. If I turn on my VPN the video connects right away. I’m using a Ubiquiti Gateway 3P and Ubiquiti AP-AC-PRO...

Is anyone having the same issue as me with the app. When the doorbell button is pressed the app will only ring on the phone if my phone is unlocked. When the phone is locked the app only vibrates and shows a notification but doesn’t make any noise. I also tried the LaView and Hik-Connect apps...

Has anyone noticed how hot this thing gets. I just installed mine today and was bench testing it and the back near the top is very hot. I’m running it off the AC bell transformer I had and I’m using it with my analog mechanical chime unit. I think I had seen someone here had mentioned they were...

I just ordered this also. Which firmware did you load onto it for rtsp support ? Sent from my iPhone using Tapatalk

I’m using gmail, it works great. Sent from my iPhone using Tapatalk

Thank you once again for being so responsive. Sent from my iPhone using Tapatalk

Sweet! Did you just use the US version of firmware? What model number does it show as after the update 7608NI-I2 ? Sent from my iPhone using Tapatalk

Mike did you ever find out from Hikvision if we can update to their firmware ?