Search results

Motion seems to only be detected by my camera number 1

This is what my setting look like. When I click Main or sub I get this blank picture. When Setting up it asks for a Channel it says "Channel (single cameras are 0, NVRs are the 0 based index)*, what does this mean? I have an NVR does that mean I set this up as 0?

H.264

Ok I installed it and in the Logbook of the Dahua device in HA it is detecting when motion passes by the camera but I havent been able to get video. So Im definitely connected to the NVR in HA but just need to figure out the video

Thanks, I will try this.

Everything in the line is correct as my NVR shows that ive logged in but thanks for the tip.

I might be on to something. I checked the log of the NVR and it showed my home assistant IP logged in logged, out logged in, logged out, all within a second as I tried to log in to the NVR with Home assistant (which is installed on my NAS) but still failed to show a connection in HA. Then...

Shows its enabled

Thanks guys

That is what I was wondering also but nothing that I could see in the settings, stood out. Thanks again for your help

"Did you tried to enable some security settings / enhancements in NVR configuration in the past?" Not that im aware of but will check. "You can try reboot NVR and after web service will come back, check one more time with VLC putting correct RTSP url with correct ip address.." I will give...

I have Nordvpn but have it turned off when trying this. yes that is they type of IP showing on my pc

I changed it to 0.000 because I didnt know if I should post my actual IP

Thanks for your patience and help. Ive been messing around with this for 3 days trying to figure it out.

Yes I use the same ip address in the RTSP line

192.168.1.154

no i just added the 0.000 Everytime I add 2 / and save the post it keeps removing a /. Not sure why but log is showing 2

On VLC I see a yellow bar that moves left and right at the bottom then an error message pops up: Your input can't be opened: VLC is unable to open the MRL 'rtsp:/user:password@192.168.0.000:554/cam/realmonitor?channel=1&subtype=1'. Check the log for details. This is the Log: -- logger module...

Good catch on the missing / i have been using two i accidently deleted it when erasing my username.

rtsp:/user:password@192.168.0.000:554/cam/realmonitor?channel=1&subtype=0 This is what im using and yes in the camera settings it shows that port is set to 554. As I said, VLC does recognize when the username and password is correct (tested using wrong one and it said wrong user or password)...

Any suggestions of what I might be doing wrong?

Is this what you need?

Thanks. Screens from the monitor or from the web based?

The NVR kit is ENS-08POE-1T Camera is a MPIX-30IRBF

I tried 1 not 0 and a couple different channels instead of 1. Yes port is 554.

I tried VLC and couldnt get it to work but it did recognize a correct username and password vs a wrong one.

Im new to this forum. I have a 8 channel Watchnet POE NVR system with MPIX cameras and I am trying to get this connected to Home Assistant using RTSP with the "Generic Camera" integration. I am using rtsp:/<Username>:<Password>@<IP Address>:<Port>/cam/realmonitor?channel=1&subtype=0 with my...