Search results

  1. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    Now time to start learning Blue Iris. Repurposed an under-utilized i5-6500 build from several years ago, did a clean install of Windows 10, and clean install of BI. This way I can review footage and do some live testing. No-light is the principal challenge at my site.
  2. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    Made a test rig from materials already at hand, to get a 5442 to a height of 8 feet 6 inches. Test rig has the vertical 2x4 at one side so the camera can be placed right up to the wall where a permanent install might be. Ran a bright color patch cable from soffit junction box to camera, casually...
  3. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    Right now the focus is to get cameras operational, later, if desired I could replace the exterior cable with nifty in-wall or interior solutions.
  4. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    By way of clarification - ethernet cable is already at soffit, in a junction box adjacent to the box the twin-head light fixture is on. This is a typical condition around the house. I am trying to go down vertically around six feet, and prefer to run cable outside, rather than conduit or molding...
  5. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    It is outdoor rated, but not direct burial. As you said, the jacket is a bit heavier and I'm hoping it will be UV resistant, though time will tell how it holds up over time. Aside: PFB mount just arrived, your input in other thread "Dahua turret mount comparison? " was timely and helpful...
  6. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    I appreciate that you are sharing your thinking. Some years ago when I was building this house I knew enough to ask my electrical sub to run me quite a few ethernet runs in the house. I guessed that about half would get used lightly or not at all, and at many places I would wish I had run more...
  7. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    That's a typical corner showing relative heights, above and behind varies from location to location, of which there are several.
  8. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    A long ethernet patch cable I had ordered for my test rig arrived. It is exterior rated and has the heft of RG6 coax cable. So far it is looking like it is what I might end up using. Have to figure out what wiring clips to use. At each location, will try to tuck the cable along existing elements...
  9. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    Thank you for your ideas.
  10. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    No flex in the material. Between rigidity, nails, and caulking, movement is not possible. Effectively it is like masonry.
  11. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    Thanks for your input. Surface install of cable or conduit into a suitable mounting box would be preferable. A camera mouning box could perhaps be installed on the vertical corner board. Demolishing the corner board to get below it, or sections of siding to get below it, would create a cascade...
  12. V

    Installing ethernet wire from 14-foot eaves soffit to 8-foot camera height

    Request input on possible ways to solve a problem depicted in attached photo. Existing ethernet wire runs are to eaves soffits which are are 14 feet from ground level. The top of the garage door trim is around 8 feet 9 inches, to give a sense of scale. I realize that cameras have to be at...
Top Bottom