no image

  1. J

    NVR Showing on SADP but not Viewable through Browser or IVMS

    I had a call from a customer recently to say the she was having issues with Playback, I attended 2 days later and the HDD symbol was solid red on the front of the NVR (So I was assuming this was a Hard drive Issue), but also in the meantime, she had lost display on the Local Monitor. I tried...
  2. N

    IPC-HFW1831E No Image and Weird Behavior

    I got a nice setup from Andy that consists of 4 IPC-HFW1831E and 52xx (I think) NVR. I tested all cameras when received and they worked great. I installed 3 out 4 cameras and they were rock solid. The 4th camera was in storage for over a year. I decided to add it to the system... Plugged in...
    • netager
    • Thread
    • dahua no image
    • Replies: 10
    • Forum: Dahua
  3. Adore

    Problem Dahua HCVR7108H

    Hello good afternoon, I have a Dahua HCVR7108H system with 4 cameras connected. The system has always worked fine, however recently in the middle of the night it started to beep. To stop the noise I turned it off and on again, and from there, it didn't work anymore! The front and inside(board)...
    • Adore
    • Thread
    • brick bricked dahua dead hcvr7108h no image no signal problem
    • Replies: 2
    • Forum: Dahua
  4. K

    HIK.NVR 7608, What is? SADP 192.1.0.64 can't ping or browser access from 254 net

    Laptop connected to one of the 8 192.168.254.n ports, SADP shows 001 ... Active, 192.1.0.64, port 8000, IPv4 gateway 0.0.0.0 and http port 80. Clearly I am missing out on some knowledge. Browser can't access it, and I can't ping it. What is it? Do I care? I have fixed IP for the NVR...
Top Bottom