5231-ze time drift

Just checked the NetTime logs and all the other cams are making requests except this one which has already drifted by around 4 seconds since I last manually synced it. My cams ip ranges from 50 to 55, the cam I’m having problems with is .50

Have just reset it to defaults will setup just NTP on it and will take it from there.

View attachment 81267
 
Last edited:
fenderman said:
The sync with pc feature is not syncing with nettime. To test if nettime sync is working, change the time to 1 hour ahead. Then set the sync interval for 1 min and see if it fixes itself. You will find that it doesnt. You need to allow port 123 UDP.
Click to expand...

Thanks for this... UDP not TCP!

Edit: my cameras never synced time and I put it on the list of things future me would troubleshoot. Thanks to fendermans comment, I checked my firewall and was not allowing UDP traffic through for NTP. Changed the rule and all cameras synced!


Sent from my iPhone using Tapatalk
 
Last edited:
the cam's UI doesn't have TCP/UDP option. if he didn't already have the port open on his FW, none of the cams would be synicng...

maybe try re-assigning the cam's IP to something other than .50? try .56 (for example) just to see if behavior changes...
 
Ok confession time

Question - When is 1 not a 1
Answer - When I’m too blind to see it

Turned that I had put in the IP address of my BI PC as 192.168.0.30 instead of 1.30 and no matter how many times I looked at it I didn’t notice/spot it.

My BI PC has dual LAN and 1.30 is the cam subnet, changed it to 1.30 and the cam is now time syncing.

Sorry for wasting people’s time but I still have learned a few things as a result of my blindness

Just need to sort out the non working microphone now, anybody have pictures of the inside of these cams, is the mic a plug in device or is it part of the main board? Wondering if it’s simply not plugged in, will pull the cam over the weekend and investigate.
 
  • Like
Reactions: samplenhold, sebastiantombs and alastairstevenson
Glad you got the NTP config sorted... in the hidsight dept: if you had posted the time config page from that cam and a working cam, someone may have noticed the issue earlier and saved a lot of head-scratching...

yes, mic should have a connector that could theoretically have come loose (or maybe just not properly mated at assembly time)...
 
  • Like
Reactions: IAmATeaf
Make sure that the audio didn't get unchecked - especially if you did an update, it may be unchecked. Also disable noise reduction for the mic.

Try those two before you take the camera down!
 
  • Like
Reactions: IAmATeaf
wittaj said:
Make sure that the audio didn't get unchecked - especially if you did an update, it may be unchecked. Also disable noise reduction for the mic.

Try those two before you take the camera down!
Click to expand...

I have checked and tested this before but given the above I’ll check again.

There is audio being recorded but it just sounds like static.
 
You must log in or register to reply here.
Top Bottom