Access into camera settings

[Super Nes]

Hi guys,

Been working on this for around 3 days straight now.

Current Setup:

Hikvision NVR DS-7616NI-SE/P

Hikvision 2CD2332-I Cameras

Now I've installed the camera run directly into the NVR PoE port. The NVR is then cabled into my router.
I have done the Virtual Server Forwarding of relevant ports.
On my PC I can access the NVR through the IP address. In doing so, I can change settings very similar to that of the settings seen when connecting a monitor directly to the NVR. (They are quite basic, image attached)

I am desperately trying to access the cameras directly so as to have the settings that everyone else seems to have.
I have now put an additional cable from my router to an NVR PoE port.
Using SADP, I can now see that it has identified the camera (picture below)



I can't seem to access that camera when inputing the IP address in my PC

Is there something I am doing wrong?
Any help to resolve this is hugely appreciated because currently my camera image quality is less than ideal, especially at night time.

 

[fenderman]

@Super Nes Welcome to the forum...see this thread http://www.ipcamtalk.com/showthread...as-web-pages-with-a-laptop-in-an-NVR-with-POE
Some hik NVR's have a virtual host in the firmware allowing access to the cameras...not sure what firmware version you need...

 

[Super Nes]

@Super NesWelcome to the forum...see this thread http://www.ipcamtalk.com/showthread...as-web-pages-with-a-laptop-in-an-NVR-with-POE

Hi there, thanks for that.

Upon all of my reading I have actually tried that with no success
I have possibly put some numbers in incorrectly somewhere, I'll try again.

 

[Super Nes]

Success!
Obviously did something different, got into the settings perfectly.

Thank you!!