Adjusting camera image on an Empiretech IPC-HDBW7842E1-Z4-X

Oct 31, 2022
364
175
Lower Alabama
I was thinking this would be a camera that I could adjust via pan and tilt, but I'm not sure how or if I can. I can rotate it, then tilt it down a little, but the image is off. I don't see a way to pan it physically. Unless I'm missing something, my only option is to move the location or mount the junction box at an angle.

As it is... I can't zoom in on the front door because it's not centered.

1752160556405.png

Rotate and tilt... but not sure if there is a way to rotate the image in the software.
1752160389806.png
 
If the movement is a lot, you need to really unscrew the tightening screws to get it to freely move. It is designed to only move a bit when you loosen them the amount you think you should.
 
  • Like
Reactions: Sonnie
You can rotate the lens 90 degree, and enable the 'rotate' setting in the cameras GUI to compensate. This feature is typically used for narrow (width) spaces like a corridor, but it may benefit you to get a better camera framing of the door
 
  • Like
Reactions: Sonnie