Blue Iris Configuration - Is this possible ?

[BigFoot]

Hello all,

I'm starting down the road of my own personal Blue Iris install and reading an awful lot about different things.

To potentially save storage space from all camera's recording 24/7 perhaps some of the more experienced could answer me a question:

Is it possible to have the camera's record on motion detection but when this triggers for ALL other camera's to also record for a pre-determined time (10 minutes or so)

Then return to motion detection ?

Any help / advice or suggestions would be greatly appreciated - thanks in advance

 

[anijet]

Put all cameras in a group then enable trigger camera groups and select the group. Make all cameras break time 600 seconds to record for the 10 min.

 

[BigFoot]

Thank you so much - very kindly appreciated

 

[BigFoot]

Am I correct in thinking that, if during the time period for all cams recording further movement is detected, then the counting-down 10 minute (in this instance) timer will restart again at 10 ?

 

[anijet]

Yes