Camera keeps defaulting to motion detect zone from another camera.

[JEO]

Last week I used the camera's WEB interface to fine tune the motion detect zones and settings. Yesterday I noticed on Smart PSS that the motion detect zone I set up for my porch cam is showing on my driveway cam. I've reset the motion detect zone for the driveway cam on the WEB, on the Smart PSS NVR and on the Smart PSS camera but when I open the driveway cam later, it again shows the motion detect zone for my porch cam. At least my porch cam isn't showing my driveway zone! Anyone experience anything like this? I rebooted the NVR this morning with no help.

 

[JEO]

NVR is 5216-4ks2 and cameras are HDW5231R-ZE.

 

[Kameraad]

Maybe not an answer directly to your problem, but why don't you use IVS? Works better than motion detection

 

[JEO]

Maybe not an answer directly to your problem, but why don't you use IVS? Works better than motion detection

I probably will. I've only recently set the system up. I wanted to experiment with MD and IVS separately to see how they perform. So far not so impressed with MD.