Constant cycling with new update.

B

brian.rtl

Getting the hang of it
Sep 30, 2014
15
33
Just updated to 3.66 and now when I view the cameras in the console they continually cycle. This is a pain because I want to review clips from only a certain camera but there is no way to stay on a single camera as the selection just toggles from one camera to the next, changing the list of associated clips.

I don't see any setting to disable this; hopefully someone has an idea (Running as service on Win 8.1)
 
It is probably this button right here:

HRIpV9h.png


If your window is not wide enough it will not appear.
 
That did the trick bp, thanks! Took a little more troubleshooting as that panel did not show on the bottom of my screen. Had to enable PTZ controls, which still didn't show the Cycle button but indicated that section wasn't showing correctly. I quit and re-launched the console and the full interface showed up so I could disable Cycle.

Thanks again.
 
You must log in or register to reply here.
Top Bottom