Dahua FW v3.. wan't flash

[MiG41]

Dear's ipcamtalk users , since this is my first post , i would like to say Hello to you.

I have two cameras IPC-HFW5541T-ASE-0280B (fw V2.840.0000000.25.R ) and IPC-HFW3841E-AS-0360B (fw V2.820.0000000.28.R ). I updated them several times with fw downloaded from dahua page.

For booth cameras they are the newest V3... wersions availble now ( DH_IPC-HX5XXX-single-Riemann_MultiLang_PN_Stream4_V3.100.0000000.6.R.230802.zip and DH_IPC-HX3XXX-Taurus_MultiLang_PN_Stream3_V3.120.0000000.34.R.230715.zip ) , but when i tring to upload .bin file for particular camera , it apears updating for a while , and then error message , and camera reboot.

What i'm doing wrong ? I only see , that before was V2... now is V3... No possible to update in this way or what ?

 

[redfive]

Most probably, your model isn't an S3 serie ...

Dahua Technology - World-leading Video-centric AIoT Solution and Service Provide

Dahua Technology

www.dahuasecurity.com

Maybe, the second one

 

[MiG41]

@redfive ,thank you , good point... On page , where i check there is nothing about S3....
What is exacly this S3 ? I can see this in newest cameras....

Is it a general rule that V3 is for S3 series ?
Second camera probably have the same case , but here this fw is for S2 : IPC-HFW3841E-AS-S2 - Dahua International

 

[wittaj]

The S designation means the chipset (and thus firmware) is different for that version of the model.