Dahua PI PTZ CAM SD49425XA-HNR Pin assignment

Stormy

n3wb
Dec 23, 2020
26
5
Austria
Hello forum!

I had water damage to the Cat plug.
Now I want to re-assemble the connector, the cable colors are the same as the standard cables.
Does Dahua use the same assignment? Have looked in the forum but found nothing.
Then I mounted the plug but couldn't find a camera with the IP address.
Or is something else broken by the water?
Suggestions for how to proceed?
Does anyone have a wiring diagram from the camera?

best regards
 
Hi,

yes, Dahua uses the standard assignments (colors are not the key, but the assigment of the wires), because I assamble all my LAN wires (CAT7 with CAT6 plugs) by my selve with this scheme and all Dahuas runs perfect:

1611161738498.png
 
Hi there !
I dont understand your plug!
I don't have your colors!
Orange / white
orange
green white
green
etc .....
 
Hello Stormy,

as I wrote, colors are not the key... the assingment must be correct, doesn't mater, what color.

For what exacly each wire is, I really don't know... but wiki does ;-) (sry for all, that I post the German wiki link, but it should be easier to understand)


And if you use POE (I dont), than this link helps:


1611166627187.png

Source: Last link above
 
Hallo Grasshoper !
Danke für deine Ausführungen . Dies ist mir klar , habe Die Buchse an der Kamera abschnitten und bekomme keine Verbindung zustande.
Ich werde morgen den defekten Stecker aufschneiden und mit dem Ohmmeter messen. Natürlich kann durch den Kurzschluss auch ein Bauteil in der Kamera defekt sein , ist sehr ärgerlich , die Kamera ist 14 Tage alt.
lg
 
Hast eine PM.
 
Hallo !
Kamera ist schon wieder o.k . Habe Sie zerlegt und einen Adapter für das kabel gebaut , neu gecrimpt und mit dem Kabeltester überprüft - spielt wieder alles - auch über POE. lg
 
Sehr gut - very good :thumb: